This is followed by switching to Manufacture, setting up my origin where I want it and programming tool paths. To answer your question about multiple set ups and UCS (user coordinate system), there is no such thing in Fusion as far as my understanding goes.įor each setup, each operation, I orient part as I intend to hold it in machine by use of "Move" command in Model.
Mastercam 2019 was does dirty refer to software#
I never once asked for assistance in this forum mostly because I could not be sure if my issue is a bug in the software or my own lock of proficiency in using it.įirst few weeks were mental torture but I had limited assistance from a coworker and I survived, have substantial inventory of parts done with help of Fusion, mostly in milling and I can't imagine my day without it. In the past two years I learned to tackle every obstacle by first forgetting how other software works, using training materials and YouTube when I needed it but mostly persisting in digging up my own solutions by trial and error. It's different software, its objective seems to be to "be all things to all people in all conceivable ways", or at least one would get that impression when looking at all the possible useful and not so useful options. I spent some time bashing Fusion for its clutter and truth is, once you learn your ways around it, it no longer matters.